[. . . ] If cabinet storage is to be provided, the risk can be reduced by installing a range hood that projects horizontally a minimum of 5" (12. € It is recommended that all electrical connections be made by a licensed, qualified electrical installer. The cooktop must be a specified cooktop that is approved to be installed either alone or over an undercounter built-in oven. [. . . ] 5 cm) minimum distance to nearest left and right side combustible surface above cooktop L. 5 cm) minimum clearance between back wall and countertop To properly install your cooktop, you must determine the type of electrical connection you will be using and follow the instructions provided for it here. , AC only electrical supply is required on a separate, 40-amp circuit, fused on both sides of the line. The model/serial number rating plate is located on the metal cabinet underneath the cooktop. Model/serial number plate 3 ■ Cooktops with 3-wire cable coming from the cooktop are rated 240 volt and do not have a neutral (white) wire. The cooktop should be connected directly to the junction box through flexible, armored or nonmetallic sheathed, copper cable. The flexible, armored cable extending from the fuse box or circuit breaker box should be connected directly to the junction box. Locate the junction box to allow as much slack as possible between the junction box and the cooktop so that the cooktop can be moved if servicing becomes necessary in the future. – ■ A UL listed or CSA approved conduit connector must be provided at each end of the power supply cable (at the cooktop and at the junction box). Connect the aluminum wiring to the added section of copper wire using special connectors and/or tools designed and UL listed for joining copper to aluminum. follow the electrical connector manufacturer's recommended procedure. Aluminum/copper connection must conform with local codes and industry accepted wiring practices. – ■ ■ INSTALLATION INSTRUCTIONS Install Cooktop WARNING Excessive Weight Hazard Use two or more people to move and install cooktop. Remove the hardware package from inside the bag containing literature. IMPORTANT: Check that the front edge of the cooktop is parallel to the front edge of the countertop. If repositioning is needed, lift entire cooktop up from cutout to avoid scratching the countertop. Using 2 or more people, gently place the cooktop in cutout and determine final location. NOTE: Make sure that the front edge of the cooktop is parallel to the front edge of the countertop. [. . . ] For more information, see the “Cooktop Care” section of the Use and Care Guide. Read the “Cooktop Use” section in the cooktop Use and Care Guide. NOTE: If the cooktop does not work after turning on the power, check that a circuit breaker has not tripped or a household fuse has not blown. [. . . ]